VOCAL Reference Design Kits allow Licensees to quickly and easily bring their secure VoIP / V²oIP products to market, at the LOWEST possible cost.

56K Modem Software

VOCAL's embedded software libraries include a complete range of ETSI / ITU / IEEE compliant algorithms, in addition to many other standard and proprietary algorithms. Our software is optimized for execution on ANSI C and leading DSP architectures (TI, ADI, AMD, ARM, MIPS, CEVA, LSI Logic ZSP, etc.). These libraries are modular and can be executed as a single task under a variety of operating systems or standalone with its own microkernel.

Depending upon configuration selected, the line interface may be an analog front end (codec and DAA) or a digital interface such as T1/E1, switched 56 and ISDN. The upper end of this software can provide PPP, V.14, HDLC or direct binary framing layers. Higher data protocol layers, V.42 (including MNP 2-4), V.44, V.42bis and MNP5 are options as well.

This modulation family can be combined with other data modulations (V.92, V.34, V.32bis/V.32, and V.22bis/ V.22/V.23/V.21). V.8/V.8bis startup procedures can be used. All data modulation software is fully compatible with VOCAL’s facsimile, telephony, speech coder and multimedia systems.

Terminology

• 56k (Determined February 1998) refers to procedures between a "digital modem" and an "analog modem". The analog modem, which may be connected to the PSTN through either an analog or digital interface, transmits V.34 signals and receives G.711 PCM signals. The digital modem, which is connected to the PSTN through a digital interface, transmits G.711 PCM signals and receives V.34 signals.
• 56k refers to analog/digital configurations. Future ITU recommendations or extensions to) may refer to digital/digital configurations and/or PCM transmit and receive for an analog/digital configuration.

Features

• Compliant with draft upgrades as recommendation is approved.
• Modem MIB Support (RFC 1696).
• Specifies 22 modulation rates in range of 28000 bps to 56000 bps, in increments of 1 1/3 kbps. (Administration requirements may restrict maximum rates/power allowed).
• Multi-tasking environment compatible.

Configuration

• As per terminology above, three system configurations are relevant: systems that implement an analog modem only, systems that implement a digital modem only, and systems in which the modem can take on the role of either an analog or digital modem.
• Analog modem DAA interface using linear codec at 16.0 kHz sample rate.
• Digital modem direct interface to 8.0 kHz PCM data stream (A-law or m-law).
• PPP (RFC1662), V.14, HDLC and direct binary framing layers available.
• North American and International Dialing/Telephony functions available.
• Data protocol layer (V.42/MNP2-4/V.44/V.42bis/MNP5) available.
• System can be combined with V.110 rate adaptation software.
• System can be combined with other modulations (V.92, V.34, V.32bis, et al.) and automode procedures (V.8bis, V.8 and PN-2330).
• Data/Facsimile/Voice Distinction upon startup available. Complete facsimile systems, modulations (V.34, V.17 et al.) and protocols (T.30), and speech coders available.

Figure 1 shows VOCAL's 56K block diagram.

Figure 1 56k Block Diagram

Block Diagram

Data Sheet